Table of Contents
Advertisement
Operation
Powering Up
Remove the back cover of the remote and insert two AAA batteries. Connect the LED load to the
controller using either the terminal blocks (as shown below, Power 1) or the barrel connector
(Power 2). Do not apply voltage to both Power 1 and Power 2 at the same time. Apply 12 or 24
VDC depending on the LED load being powered.
Do not press the touch wheel while loading the batteries. This will affect the sensitivity of the
touch wheel. Loss of sensitivity in the touch wheel is also an indicator of low battery charge.
The LinkUp family is intended for use with either the included remote or the Android/iPhone
app (requires the linkup-wifi). Each of these options provides the same broad range of
functionality. The LinkUp products are not, however, compatible with your home wifi system or
any other software applications.
Pairing Receiver to Remote
Each receiver must be paired with the remote in order to function. Turn the power to the receiver
off, wait 10 seconds, and return power. Tap the (Speed) S+ button on the remote as soon as the
lights turn on. The LED will blink to confirm the match. Repeat this, pairing an unlimited
number of receivers within working distance to your remote. Each receiver may be paired with
up to four remotes. To delete the pairing, turn off power to the receiver. When you restore
power, hold down the S+ button for five seconds. Lights will blink to confirm.
Setting and Adjusting Lights
To select a color, simply touch a point on the color wheel. From there, the (Brightness) B+/-
buttons can be used to further adjust the light.
Press the (Mode) M+/- button to scroll through the pre-programmed modes listed below. When
you reach mode 20 you will have to use the M- button to return to the previous modes on the list.
Brightness can be increased or decreased in modes as with a static color.
Copyright EnvironmentalLights.com
4
All Rights Reserved 10/10/14
Wire Name
Connection
B
Blue
G
Green
R
Red
+
Power
Advertisement
Table of Contents
