Installation; Minimum Distances; Installing The Template - Ariston ELYOS Series Installation Manual

1.

INSTALLATION

1.1 Minimum distances

To ensure the appliance is installed correctly, keep to
the minimum distances indicated in fi gure "A" and leave
enough room for air to circulate freely.
Use the accessories provided with the appliance to carry
out the installation properly.
NOTES:
The dimensions of the internal and external units are
given at the back of the manual.
WARNING:
- Make sure the installation site and any systems
to which the device must be connected comply
with the applicable regulations.
- Use manual tools and equipment that are suit-
able for the intended use.
- When lifting loads with a crane or hoist, make
sure the equipment used for lifting is stable and
effi cient and suitably sized for the movement
and weight of the load itself; place the load cor-
rectly in slings, tie ropes around it to limit any
oscillations and lateral movements; lift the load
from a position where there is a full view of all
the space covered by the load during lifting; do
not allow people to pass or stop in the vicinity of
the suspended load.

1.2 Installing the template

NOTES:
Install the internal unit in a place free from all obstacles
(such as curtains) that could hinder the receipt of the
remote control signals and that allows for the air fi lters
to be pulled out without causing any inconvenience.
Install the internal unit in a place where the air fl ow is
not obstructed
WARNING:
Install the template on a solid wall that is not sub-
ject to any vibrations.
1. Using a mason's level, position the template in such a
way as to ensure it is perfectly on-axis, both vertically
and horizontally.
2. Fasten the template with 6 screws. Be careful not to
pierce or damage any pipes or wiring in conduits (risk
of personal injury from electrocution).
3. Then use the other screws to fasten the template to
the wall uniformly on all its surface.
4. Make a hole in the wall for all piping and electrical
connections to pass through.
250
300
300
600
A
A B
2,5 kW 195,5 75
3,5 kW 195,5 75
Fig. "A"
150
250
300
600
300
600
E
B
C D E
40 70 160,5
40 70 160,5
GB
ø D
19