Hoover DOMINO HVE32 Use And Maintenance Manual page 22

Safety cut-out
If one or more burners are accidentally left on, the control automatically turns them off after a certain time has elapsed. The table
below indicates the time interval, which depends on the power level setting.
Level
1 – 2
3 - 4
5
6 – 9
If the safety cut-out has tripped, the symbol "H" is displayed.
To avoid the automatic cut-out being tripped, simply touch the burner selection key or the "+" or "-" keys before the time runs out.
5. Automatic preheating
This automatic device facilitates the cooking process because you do not need to supervise the whole cooking cycle.
This function preheats the burner on maximum power in order to bring it rapidly up to the required temperature. After a given time
interval, the power level returns spontaneously to the established setting.
Enabling automatic preheating
Select the burner concerned by means of the key (2).
Select level 9 by means of the "-" key, then select level 9 with the "+" key.
Finally select the required power setting, e.g. level 6, with the "-" key.
In automatic preheating mode, the display for the burner concerned will
alternately show the actual setting ("6") and the symbol "A".
Example: Select level 9 to enable automatic preheating with the "+"
key. Then bring the level down to 6 using the "-" key. In this
way, the burner will be preheated on full power for 2'30",
while the display alternately reads "A" and "6". After 2'30" the
burner will return to the power level 6.
Level
1.
2 3'
3
4
5
6
7
8
9
Changing the power level in the automatic preheating phase
1. The burner involved must be on. The decimal point (13) for the
corresponding burner must also be on.
2. Change the level by means of the "+" and "-" keys.
If the setting is raised, the new preheating time is recalculated taking the
time that has already elapsed for the previous setting into account.
Example: Level 1 is selected, corresponding to a preheating time of 1'.
Thirty seconds later, the setting is raised to 4. On this level, the preheating time is 6'30".
Following this change in setting, the automatic preheating time will last a further 6' (resulting from the subtraction 6'30" –
30").
Disabling the automatic preheating function
With the symbol "A" showing on the burner display:
1. The burner concerned must be on.
The decimal point (13) for the burner concerned must also be on.
2. Touch the "-" key (4) at least 10 seconds after enabling the
function.
Time limit (hours)
6
5
4
1.5
Time limit
1'
4'48"
6'30"
8'30"
2'30"
3'30"
4'30"
......
22