Cisco 7513 Series Manual page 22

Replacing or Upgrading the Chassis
Step 7
Step 8
Step 9
Step 10
Step 11
Figure 10
Note
This completes the processor module removal and replacement procedure. If you need to install the
new chassis in an equipment rack, proceed to the "Installing the New Chassis in the Rack" section
on page 15. Otherwise, proceed to the next section to check the installation.
22 Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions
Place the processor module in the same slot position in the new chassis and align the
notches along the edge of the carrier with the grooves in the slot. (See Figure 9a.)
While keeping the carrier at a 90-degree orientation to the backplane, carefully slide the
carrier into the slot until the back of the faceplate makes contact with the ejector levers,
and then stop. (See Figure 9b.)
Do not use unnecessary force when installing processor modules. Always guide the
carrier into the slot only until the carrier faceplate makes contact with the ejector levers;
then use the ejector levers to complete the insertion.
Using the thumb and forefinger of each hand to pinch each ejector, simultaneously push
both ejectors inward (toward the carrier handle) until they snap into place and are at a full
90-degree orientation to the faceplate. (See Figure 9c.) The carrier ears (the ends of the
faceplate) should be flush against the chassis.
Use a screwdriver to tighten the two captive screws to prevent the processor module from
becoming partially dislodged from the backplane and to ensure proper EMI shielding.
Repeat Steps 2 through 10 for the remaining interface processors.
Handling a Processor Module
Leave the interface processor filler installed in any unfilled interface processor slots.