Table of Contents
Advertisement
Precautions for Use
Disclaimer
•
Please note that JVCKENWOOD shall not be responsible for any damages suffered by the customer or a third
party as a result of incorrectly using this
product,
a failure during use of this product, or other
trouble,
or due
to the use of this product, unless such liability is acknowledged by law.
Copyrights
• Recorded
video, image, and audio content cannot be used for other than personal enjoyment without the
consent of the copyright holder as specified in the Copyright
Act.
• Please
note that the recording of an event such as a show, performance, or exhibition may be restricted even
when doing so for personal
enjoyment.
Precautions and notices
Warning!
Do not operate the device while driving. Using this product does not change the requirement for a
driver
to take full responsibility for his or her behavior.
This
responsibility includes observing all traffic
rules
and
regulations
in order to avoid accidents, personal injury or property
damage.
•
For your own safety, do not operate the controls of the
product
while
driving.
•
A window mount is needed when using the device in a car.
Make
sure that you place the
recorder
in an
appropriate
place,
so as not to obstruct the driver's view or deployment of
airbags.
• Make
sure that no object is blocking
the
camera lens and no reflective material is placed near the
lens.
Please
keep the lens clean.
•
If the car's windscreen is tinted with a coating, this may impact the recording quality.
•
Connect the charger to a proper power
source.
The voltage requirements are found on the
product
case and/or
packaging.
•
Do not use the charger if
the
cord becomes damaged.
• Do not attempt to service the unit. There are no serviceable parts
inside.
Replace the unit if it is damaged or
exposed to excess moisture.
Precautions for installation
• Install
the device in a position where it will not block the front view of the driver (position where hidden by the
rear-view mirror).
• Install the
device so that it is within the wiping range of the
wiper.
• Install the
device in a position where it will not interfere with the movement of the rear-view
mirror.
•
Take care
not
to install the device over the vehicle inspection sticker or other sticker.
•
Take care not to install the device where it will interfere with driving or airbag
operation.
• When
installing the device in a vehicle equipped with
a
driving support system, check the instruction manual of the
vehicle and then select an installation position that will not interfere with the driving support system.
•
If the device is installed incorrectly, event
recording
or parked recording may not work
correctly.
•
Refer to •installation and Connection" for the
loosening
of fixing knob, installation orientation, installation
angle, and other information and then install the
device
correctly.
• Do not install the device near a digital terrestrial television antenna or an electrical component.
•
Doing so may reduce television receiver sensitivity or cause flickering and noise.
•
When selecting a position for the suction mount, make sure it's on a glass surface that is smooth and free of
paint.
•
Before mounting, clean the area with a dry/clean cloth and add a small amount of moisture
to
the
windshield.
This allows a stronger
bond
to form between the glass and the suction mount.
•
When fixing the device with the adhesive mount, use a commercially available cleaning cloth or the like to wipe
off all dirt and grease on the mounting surface. If the device is re-affixed or mounted using, for example,
general-purpose double-sided tape, the adhesion strength may weaken and cause the device
to
fall.
•
After mounting the device,
leave
it for 24 hours before use to enable the mounting strength of the adhesive
mount to
improve.
Failing to
do
so may result in the adhesion of the adhesive mount becoming weak and the
device
falling.
•
Fix
the
cord in place with tape or the like so that it does not interfere with driving.
Precautions for use
•
Do not block the camera lens, get dirt on it, or place a reflective object near
it.
•
When
LED
traffic
lights
are recorded, video in which they appear to
be
flickering or flashing may be recorded.
JVCKENWOOD
assumes no responsibility with regard to
the
distinguishing or recording of traffic
lights.
• If
coating is used on the windshield of the vehicle, recording
quality
may be
affected.
There
is
no
guarantee
that the device can record video in all conditions.
Hide quick links:
Advertisement
Table of Contents
