Page 1
2019 Data Switch‐Remote Power Control Reset (DS‐RPC) Copyright 2019 Bay Technical Associates, Inc 2/1/2019 ...
Page 2
DSRPC Factory Reset: To reset the DS-RPC unit’s outlets to factory default, use the following instructions: Hardware Revision lower than H2.0* and DS2-RPC 1. Remove the top lid of the DS-RPC chassis. 2. Locate jumper J15 (Blue Arrow) in the center of the receptacle board. (This is a two-pin jumper.) 3.
Page 3
DS4(A)-RPC and Hardware Revision H2.0 or higher* To reset the DS-RPC unit’s outlets to factory default, use the following instructions: 1. Remove the top lid of the DS-RPC chassis. 2. Locate jumper JP1 (Blue Arrow) in the center of the receptacle board. (This is a two-pin jumper.) 3.