Connecting The R&S Tsma-Bp Battery Pack Unit With External Power Supply - R&S TSMA-BP Getting Started

®
R&S TSMA-BP
Connecting the R&S TSMA-BP Battery Pack Unit with External Power Supply
The R&S TSMA Base Unit boots as soon as the R&S TSMA-BP Battery Pack
Unit (including charged batteries) is connected with the R&S TSMA via the con-
nection cable (3).
4.4 Connecting the R&S TSMA-BP Battery Pack
Unit with External Power Supply
The connection of an external DC power supply offers the following possibilities:
● Operating the R&S TSMA Base Unit via the power supply
● Recharging the batteries in case the R&S TSMA Base Unit is switched off
In order to recharge the batteries of the R&S TSMA-BP Battery Pack Unit without
a separate charger, connect the R&S TSMA-BP Battery Pack Unit with an exter-
nal power supply.
The external recharging of the batteries is only allowed via the separate
charger (R&S TSMA-BC2, R&S No. 1523.8015.02).
The following steps must be performed.
1. Connect the R&S TSMA Base Unit (1) with the R&S TSMA-BP Battery Pack
Unit (2) using the connection cable (3).
Note: In this case, the R&S TSMA Base Unit will boot immediately.
2. Connect the DC OUT of the AC power supply (R&S TSMA-Z1, R&S
No. 1523.8450.02) with the R&S TSMA-BP Battery Pack Unit (4) with the
adapter cable (5).
3. Connect the adapter cable (5) with the AC power supply (R&S TSMA-Z1).
In this case, the TSMA is supplied via the AC power supply and the batteries
will be recharged slowly. If the R&S TSMA is switched off, the batteries will be
recharged.
Getting Started 1177.5885.02 ─ 05
Preparing for Use
15