LG LPT-DW113P Owner's Manual page 13

7) Click [Add].
The new IP address is displayed in the IP
addresses option.
8) Click [OK] or [Close] repeatedly to save the
settings.
5. Start the web browser on the computer.
6. Enter the IP address (192.168.1.8) of the camera
into the Address bar and press Enter.
The home page of the camera is displayed.
Note:
If the Home page does not displayed, check the
IP settings of the computer or reset the camera.
7. For more detail using the home page of the
camera, refer to [Setup configuration] and
[Operating].
How to reset the camera
1. Detach the Ceiling Mount Assembly from
the camera body and find Dip switch as
shown right.
2. Set the first dip switch to ON and wait 5 sec-
onds in power on mode.
ON
OFF
3. Set to OFF the switch after 5 seconds.
Wait 2 minutes or more after reset.
The network settings will be changed to
default values.
4. Attach the Ceiling Mount Assembly to the
camera body.
Note:
The factory default settings are as shown below.
• Server Title: LPT-DW113.
• Port numbers
- Web server port: 80
- Login port : 9000
- Stream port: 9001
- Audio port: 9002
- Interactive audio port: 9003
• IP Setup
- IP address: 192.168.1.8
- Subnet mask : 255.255.255.0
Gateway: 192.168.1.1
• DNS Server
- First DNS server: 164.124.101.2
- Second DNS server: 210.104.1.3
• Login ID and Password of Administrator
- ID: admin
- Password: admin
13