Technical Features - LAVAZZA LB 951 Instructions Manual

Hide thumbs Also See for LB 951:

Instructions manual (10 pages)

Table Of Contents

Table of Contents

Available languages

SETTING THE PRE-DOSED SUPPLY BUTTON DOSES

Press down the supply button to be modified for at least 3 seconds: the machine will notify a signal, i.e. the

LED will blink (1 second ON, then 1 second OFF).

Release the button (the coffee supply will start).

Once the desired amount of coffee has been obtained, stop supply by pressing the same button.

• The minimum dose that can be set is 20 cc.

• If the programming does not end within 110 seconds, the supply will be stopped automatically. The

machine will notify a signal, i.e. the LED will blink (1 second ON, then 1 second OFF) and the last dose

previously set will be stored into the memory.

• To resume the factory-set values for the set doses, simultaneously press down the two pre-dosed supply

buttons for 5 seconds.

SOLUTIONS TO THE MOST COMMON PROBLEMS

Problem

The machine does not turn on.

The machine produces water rather

than coffee.

The machine takes a long time to

heat up.

The pump is very noisy.

The machine will not supply the

product and the button will blink.

The capsule loader lever will not

close.

The coffee gushes out too quickly

and the espresso cream does not

form.

The three coffee supply buttons will

blink simultaneously.

• Voltage:

• Total wattage:

• Power absorption (stand-by mode): , 0,5 W

• Tank capacity:

• Dimensions:

Possible causes

The machine is not connected to

the electric power supply.

The capsule loader lever is up.

The machine has a lot of calcium

deposits.

There is no water in the tank.

Used capsule drawer is full.

Capsule not inserted properly.

The capsule has already been

used.

Water heating system damaged.