Correction Of Malfunctions - WAGNER TexPerfect Manual

Spray attachment

Hide thumbs

Table Of Contents

Table of Contents

Available languages

TexPerfect spray attachment

Assembly

The nozzle, air cap and needle are optimally adjusted to suit each other. Do not

combine components from different spray attachments, as the components

could be damaged.

CAUTION! The units may only be used with a functional valve. If paints

rises in the ventilating hose (Fig. A, item 16) do not operate the unit

further! Dismantle and clean the ventilating hose, valve and diaphragm

and replace the diaphragm if necessary.

Do not lay the spray gun.

1. Place the diaphragm (fig. A, 14) with the pin facing upwards on the bottom section

of the valve. Also see the marking on the gun body.

2. Place on the valve cover (fig. A, 15) and screw it closed.

3. Place the ventilating hose (fig. A, 16) on the valve cover and on the nipple at the gun

body.

4. Push the nozzle seal over the needle; the groove (slot) should point towards you

(fig. 7).

5. Place the nozzle on to the gun body with the recess facing downwards. (Fig. 8)

6. Put the air cap (fig. 9, 2) onto the nozzle (3) and tighten it using the union nut (1).

7. Place the container seal from below on the suction tube and slide it over the collar,

while turning the container seal slightly.

8. Insert the suction tube with container seal in the gun body.