Interruption Of Work; Shutting Down And Cleaning - WAGNER TexPerfect Manual

GB

Interruption of Work

•
Turn the machine off.
•
With fine plaster, observe the maximum processing time (usually 20-30 minutes). If
the spray attachment is not used for a slightly longer period, clean it, as the material is
hard to remove once dry.
•
During longer breaks, vent the container by briefly opening and then closing it again.
•
Clean nozzle openings after an interruption in operation.
Make sure that the container is secure when setting down the TexPerfect
i
spray attachment.

Shutting down and cleaning

Please also refer to the instructions of the basic device.
With masonry paint, fine plaster, structured paint and undercoats we
i
recommend using warm water for cleaning.
1. Switch the unit off.
2. Unscrew the container and empty it. Pull out the suction tube with container seal.
3. Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 1, B).
4. Pour water into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
5. Turn on the machine and spray the water into a container or a cloth.
6. Repeat the above procedure until the water emerging from the nozzle is clear.
7. Turn off the machine and remove the plug.
8. Unscrew the container and empty it. Pull out the suction tube with container seal.
We recommend the use of a common household washing-up brush to clean
i
the container.
CAUTION! Never clean seals, diaphragm and nozzle or air
holes of the spray gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
9. Pull the ventilating hose (fig. A, 14) at the top from the gun body. Screw off the valve
cover (15). Remove the diaphragm (16). Clean all the parts carefully.
10. Unscrew the union nut (fig. 6, 1) and remove the air cap (2) and nozzle (3). Clean the
air cap, nozzle seal (4) and nozzle with a brush and water.
4
TexPerfect spray attachment