WAGNER TexPerfect Manual page 6

GB
Preparation of the Coating Material
Spray material that is at least at room temperature provides a better spray
i
result.
The spray attachment can spray masonry paint, fine plaster, structured paint and undercoats
undiluted or partially diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Masonry paint, undercoats, sealing primer
Fine plaster
Structured paint
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 %
until the feed rate meets your requirements (observe the maximum permitted
dilution as stipulated by the manufacturer).
Preparing the wall
The spray result depends heavily on the smoothness and cleanliness of
i
the surface to be sprayed. Fine plaster cannot be used to level bumps or
holes in the wall. Therefore the surface should be carefully prepared and
kept free of dust.
Depending on the surface, it might be necessary to apply a suitable sealing primer/
undercoat before spraying the fine plaster on the wall. Please observe the information
about this that is provided by the manufacturer of the material.
Adjusting the material quantity
Very high quantities can be processed with this attachment. In order to prevent the material
from dripping, test the flow rate by spraying the material on to a piece of card or paper first.
First turn the adjustment knob (Fig. 1, Item 9) fully to the left (-) and then slowly increase
the material quantity to the desired amount by turning it to the right (+).
Recommended flow rate:
i
For masonry paint select a medium or high flow rate.
For fine plaster and structured paint, the material flow should be adjusted
to the grain size. When using larger grain sizes (e.g. 1 mm) a high flow rate
should be set.
For undercoats/sealing primer, a low flow rate is recommended.
2
Thinning recommendation
TexPerfect spray attachment
undiluted
dilute by 0-5%
observe manufacturer's instructions