Advertisement
1
COMMUNICATION SETTINGS
4800 BAUD
8 DATA BITS
ODD PARITY
1 STOP BIT
2
ASSIGN ADDRESS
Somfy's configuration software is located on-line at: http://www.somfy.us/Apps/SDNSoftware/ILT2-ST30-3.5.2.exe
A USB to RS485 converter is recommended (Part 9015260).
1. Select the correct COM port.
2. Click on "RTS", then click on CONNECT
3. Click on "Get MTR Addr." The default address, ABCDEF, will appear if unprogrammed.
4. Under Group Addresses, Assign an address to Group 1. It should be a 6bit Hex Address. This will then become the Motor Address for
the Glydea.
5. Up to 5 Group Address can also be assigned at this time in locations 2 through 6.
6. Click on "Set". Allow 10 seconds for data transfer between PC and Motor.
7. Click on "Get MTR Addr" and verify the motor address has been updated.
8. Click on "Get" under GROUP ADDRESSES and verify the group addresses are set correctly.
GLYDEA MOTOR with RS485
Programming Guide
Advertisement
Table of Contents
Related Manuals for SOMFY GLYDEA
Summary of Contents for SOMFY GLYDEA
- Page 1 8 DATA BITS ODD PARITY 1 STOP BIT ASSIGN ADDRESS Somfy’s configuration software is located on-line at: http://www.somfy.us/Apps/SDNSoftware/ILT2-ST30-3.5.2.exe A USB to RS485 converter is recommended (Part 9015260). 1. Select the correct COM port. 2. Click on “RTS”, then click on CONNECT 3.
- Page 2 2. Enter the Motor Address just assigned. Click on “All Commands”. 3. Click on “Calculate”. All the command strings will be filled in automatically. 4. Only the following commands can be used with the Glydea Motor: UP , STOP and DOWN...
Need help?
Do you have a question about the GLYDEA and is the answer not in the manual?
Questions and answers