Advertisement
To Install the DIM Module
1) Remove the PL/PS-B unit's cover.
1. Removing the Cover.
2) Install the DIM module in the empty
socket.
3) Position the Alignment Grooves so
that they fit the Alignment Pins.
4) Insert the DIM module into the
socket.
5) Push the DIM module down until
the ejector tabs lock.
6) Replace the PS-B unit's cover and
reattach all four (4) attachment
screws. The torque should be 0.6
to 0.8 N•m. If you used only the
maintenance cover, replace that
cover and fasten the its (2) attach-
ment screws. The torque should
be 0.5 to 0.6 N•m.
<For PL>
DIM Module
Empty Socket
<For PS-B>
Rear face of
PS-B
DIM Module
Alignment Grooves
Alignment Pins
-7-
Advertisement
