Burn Hazard; Technical Characteristics - Coleman 5132 Series Instructions For Use Manual

CAUTION
SERVICE SAFETY
• Use only propane set up for vapor
withdrawal.
• Keep all connections and fittings
clean. Inspect propane cylinder and
lantern propane connections for
damage before attaching.
• During set up, CHECK FOR LEAKS
in one or more ways: Apply soapy
water to connections. Look for
bubbles. Listen for hiss of escaping
gas. Feel for extreme cold. Smell for
rotten egg odor. Never use a flame.
Do not use if leaking.
• Use as a lighting appliance only.
• Never alter in any way or use with
any device or part not expressly
approved by Coleman.
• Never use as a space heater.
• Always use in upright position.
Protect cylinder from excess heat.
WARNING

BURN HAZARD

• Never leave lantern unattended when
hot or in use.
• Keep out of reach of children.
WARNING
Not for home or recreational vehicle
use. We cannot foresee every use
which may be made of our products.
Check with your local fire safety
authority if you have questions
about use. Other standards govern the
use of fuel gases and heat producing
products for specific uses. Your local
authorities can advise you about these.
• Never refill disposable cylinders.
• Use the preset regulator that came
with the lantern. Do not attempt to
adjust.
• Use only Coleman
parts. During lantern set-up, check
all fittings for leaks using soapy
water. Never use a flame.
Technical
Characteristics
Input: 2,000 BTU/h
Category: Pressure regulated propane
Fuel: 16.4 oz. disposable propane
cylinders
Regulator: 5132
accessories or
®
English - 3
To Set Up
DANGER
CARBON MONOXIDE HAZARD
• For outdoor use only.
• Never use inside house, camper,
tent, vehicle or other unventilated
or enclosed areas. This lantern
consumes air (oxygen) and produces
carbon monoxide (CO). Do not use
in unventilated or enclosed areas to
avoid endangering your life.
CAUTION
SERVICE SAFETY
• Keep all connections and fittings
clean. Inspect propane cylinder and
lantern propane connections for
damage before attaching.
• During set up, check all connections
and fittings for leaks using soapy
water. Bubbles indicate a leak. Never
use a flame.
WARNING
For INSTASTART™ Lanterns only:
• Place mantle between burner and
electronic ignition electrode. Do
not damage mantle with electrode.
Holes or tears in mantles damage
the mantle.
■ Take lantern outdoors away from
ignition sources.
■ Lift cover. (Fig. 1)
■ Remove globe. (Fig. 2)
Fig. 1 Fig. 2