Xycom XVME-654 Manual page 35

Option Description
Previous Boot Detects if a boot sequence was not completed properly, if enabled. An incomplete
boot may be caused by a power failure, reset during boot-up, or invalid CMOS
configuration. If the BIOS detects this condition, it will display the following message:
"Previous boot incomplete - default configuration used." The system will be rebooted
using the default configuration. If this option is disabled, the system BIOS will not
detect an incomplete boot. As a result, the system may not boot if the CMOS
settings are wrong. The default is disabled.
Boot Sequence Attempts to load the operating system from the disk drives in the sequence selected
here. The default is A: then C:
Setup Prompt Displays the message, "Press <F2> for Setup," during boot up. The default is
disabled.
POST Errors Halts the system if it encounters a boot error when enabled, and will display "Press
<F1> to resume, <F2> for Setup." The default is enabled.
Floppy Check Seeks diskette drives on the system during boot up if enabled. Disabling speeds
boot time. The default is enabled.
Summary Screen Displays system summary screen during boot up, when enabled. The default is
enabled. This screen is a standard Phoenix BIOS screen and provides information
on the following items:
Processor Type
Coprocessor Type
BIOS Date
System ROM Address
System RAM
Extended RAM
Shadow RAM
Cache RAM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table Chapter 3 -3. Boot Sequence Sub-menu Options
COM Ports
LPT Ports
Display Type
Hard Disk 0
Hard Disk 1
Diskette A
Diskette B
Chapter 3 – BIOS Setup Menus
3-8