Table of Contents
Advertisement
IDE Adapter 0 Master and Slave Sub-menu
The IDE Adapter 0 Master and Slave sub-menus are used to configure IDE hard drive
information. If only one drive is attached to the IDE adapter, then only the parameters in
the Master Sub-menu need to be entered. If two drives are connected, both Master and
Slave Sub-menu parameters will need to be entered. The Master and Slave sub-menus
contain the same information.
PhoenixBIOS Setup–Copyright 1985-95 Phoenix Technologies Ltd.
Main
IDE Adapter 0 Master (C: 260 Mb)
Autotype Fixed Disk:
Type:
Cylinders:
Heads:
Sectors/Track:
Write Precomp:
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
↑↓
F1
Help
←→ Select Menu
ESC
Exit
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[Press Enter]
[User] 260 Mb
[907]
[
14]
[
40]
[None]
[8 Sectors]
[Enabled]
[Disabled]
[Standard]
Select Item
-/+
Enter Select » Sub-Menu
Figure Chapter 3 -2. IDE Adapter Sub-menu
Chapter 3 – BIOS Setup Menus
Item Specific Help
If the line item you
are viewing has
specific help, it will
be listed here.
Change Values
F9
F10 Previous Values
Setup Defaults
3-4
Advertisement
Table of Contents
Need help?
Do you have a question about the XVME-654 and is the answer not in the manual?