General Instructions For Gasburners; Installation; Maintenance - Bentone BG550 Series Installation And Maintenance Instruction

15. General instructions for gasburners

15.1

Installation

1. Follow standards and instructions applicable to the
installation of gas burners
2. Ensure that the electric installation is made in
accordance with existing regulations
3. Check that the fresh air intake of the boiler room is
suficiently dimensioned
4. Check by studying the data plate that the eficiency
of the burner is adapted to the boiler output
5. Check that the burner is adapted to the gas quality
in question

15.2 Maintenance

General instructions
1. Keep the boiler room clean
2. Ensure that the fresh air intake of the boiler room is
not restricted
3. Switch off the current and shut off the gas supply if
the burner must be withdrawn from the boiler
4. Do not use the boiler for burning paper and waste
if there is no special arrangement ( ire room ) for
this
Om brännaren har stannat
1. Tryck in återställningknappen på reläet
2. Kontrollera att max. termostaten inte löst ut
3. Kontrollera andra termostater ex. rumstermostat
om sådan inns
4. Kontrollera att tillräckligt gastryck inns till brännaren
5. Undersök att de elektriska säkringarna är hela
6. Kontrollera vid nytt startförsök genom att iakttaga
på gasmätarens räkneverk att magnetventilen
öppnar
5. Om brännaren inte startar trots upprepat startför-
sök meddela då installatören
Authorized installer
____________________________________________________________________________________________________
Adres:______________________________________________________________________________________________
Tel:______________________________________________________________________________________________
6. Check that the input pressure of the gas is correct
7. Check that the dampers of the boiler are open
8. Check that there is water in the system
9. Check that thermostats etc. are correctly adjusted
10. Read the instructions and follow the directions
given for the burner as to starting-up and service
Normal operation
1. Ensure that the air supply to the burner is not
obstructed by dust and dirt
2. Have the installer make a yearly overhaul of the
installation so that safety is not jeopardized
3. Have the installer at the yearly overhaul also adjust
the burner to ensure optimal combustion economy
4. Check periodically that there is water in the system
( ill up if necessary ) and that thermostats etc. are
normally adjusted
5. Ensure that there is no water or dampness in
contact with the burner
Shut-Off
1. Switch off the current with the main switch
2. Shut-off the gas supply with the shut-off cock on
the burner
Warning
1. Never keep your face in front of the ire room door
when starting up the burner
2. Do not use naked lame when inspecting the ire
room
General
Bentone BG550/650
49