Advertisement
Quick Links
Advertisement
Related Manuals for IFM Electronic O5E5 A Series
Summary of Contents for IFM Electronic O5E5 A Series
- Page 1 Operating instructions Through-beam sensor O5E5xA O5S5xA...
-
Page 2: Preliminary Note
1 Preliminary note 1.1 Symbols used ► Instruction > Reaction, result […] Designation of pushbuttons, buttons or indications → Cross-reference Important note Non-compliance can result in malfunctions or interference. 2 Safety instructions • Please read this document prior to set-up of the unit. Ensure that the product is suitable for your application without any restrictions. -
Page 3: Installation
4 Installation transmitter receiver ► Install the receiver (O5E...) and secure it to a bracket. ► Align the transmitter (O5S...) to the receiver and fix it. Maximum range is only possible with precise alignment. 5 Operating and display elements receiver 1: LED 2: [OUT on] 3: [OUT off]... - Page 4 ► Disconnect power. ► Connect the unit as follows: Receiver DC PNP pin 1 = L+ (pin 2 = not connected) pin 3 = L- pin 4 = load Transmitter DC pin 1 = L+ (pin 2 = not connected) pin 3 = L- (pin 4 = not connected) 7 Settings...
-
Page 5: Operation
7.2 The sensor is not to switch when the object is detected ► Position the object (see figure 1) and press [OUT off]. ► Remove the object (see figure 2) and press [OUT on]. The setting can also be carried out first without object and then with object. 7.3 Setting of the maximum sensitivity ►...