1 Preliminary note 1.1 Symbols used ► Instruction > Reaction, result […] Designation of keys, buttons or indications → Cross-reference Information Supplementary note� Important note Non-compliance may result in malfunction or interference� 2 Safety instructions • Read this document before setting up the product and keep it during the entire service life�...
4 Installation ► Fit the prismatic reflector or the reflective tape behind the object to be detected� Align the retro-reflective sensor to it and secure it to a bracket� > Maximum range only with accurate alignment� 5 Electrical connection The unit must be connected by a qualified electrician� ►...
6 Settings 6.1 Set via IO-Link This unit has an IO-Link communication interface which enables direct access to process and diagnostic data� In addition it is possible to set the parameters of the unit while it is in operation� Operation of the unit via the IO-Link interface requires an IO-Link master�...
6.1.2 Set maximum sensitivity ► Start the LR DEVICE software� ► Align the sensor so that no light is reflected� ► Select [Teach SP1 TP1] in the LR DEVICE software� ► Select [Teach SP1 TP2] in the LR DEVICE software� 7 Operation ►...