Canon MultiPASS C50 Service Manual page 51

Connecting the Power Cord
Follow these guidelines when connecting your MultiPASS C50 to a
power source:
Caution
The MultiPASS C50 is intended for domestic use only and requires
200–240 V AC. Do not use it outside the country where it was
purchased.
Use only the power cord that came with the unit. Using a longer
cord or extension cord can cause the MultiPASS C50 to malfunction.
Unplug the unit only by pulling on the plug itself. Never pull on the
cord.
Do not plug the MultiPASS C50 into an outlet shared with an
appliance such as an air conditioner, computer, electric typewriter,
or copier. These devices generate electrical noise, which can
interfere with the MultiPASS C50's operation.
Make sure nothing is laying on the power cord, and that the cord
cannot be walked on or tripped over.
Do not overload the electrical outlet. Make sure the total amperage
used by all the machines plugged into the outlet does not exceed the
ampere rating of the outlet's circuit breaker.
Make sure the operation panel of the MultiPASS C50 is properly
closed, and that there are no documents in this area.
Connect the power cord as follows:
1. Plug the supplied power cord into the power receptacle on the
MultiPASS C50.
2. Plug the other end of the power cord into the outlet.
Chapter 1: General Description
1-31
IB2-18