Canon MultiPASS C50 Service Manual page 262

Part 2: Printer
5.3.2 Hexadecimal dump print
You can set the printer so that it prints the hexadecimal code data. Then, when the printer receives print
data from the computer, it converts and prints in the hexadecimal code.
You only need to set this function if you decode the print data from an application program that does not
send the print data correctly.
In this mode, each byte of data from the computer is printed as hexadecimal data in units of 16 bytes per
line. Remaining data less than one line long are printed when the printer mode is finished.
In order to output the hexadecimal dump print, you have to change the service data switch settings in
facsimile mode. In Service data – #7 PRINTER – 5. HEX DUMP MODE, select Yes = (*), then, when
printer mode is entered, by selecting #4 DOS PRINTING with the SPECIAL MODE , a hexadecimal
dump print is output.
To stop the hexadecimal dump print select the #4 DOS PRINTING again, and go back to facsimile mode,
and select #7 PRINTER – 5. HEX. DUMP MODE No = (#). Then, when you return to the printer mode,
normal printing is resumed.
Figure 3-1 Hexadecimal Dump Print (Sample)
3-6