Installing And Removing A Memory Module; Dimm Population Table - Gigabyte MU71-SU0 User Manual

1-4-2 Installing and Removing a Memory Module

Before installing a memory module, make sure to turn off the computer and unplug the
power cord from the power outlet to prevent damage to the memory module.
Be sure to install DDR4 UDIMMs on this motherboard.
Follow these instructions to install a DIMM module:
1. Insert the DIMM memory module vertically into the DIMM slot and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.
Note: When popula ng DIMMs into a channel, slot numbers having the suffix "0" must be populated first,
then followed by slot numbers having the suffix "1".

1-4-3 DIMM Population Table

Ranks Per DIMM
Type
and Data Width
RDIMM
RDIMM
RDIMM
RDIMM
RDIMM 3DS
LRDIMM
LRDIMM
3DS
2
DIMM Capacity (GB)
4Gb*
SRx8 4GB
SRx4 8GB
DRx8 8GB
DRx4 16GB
QRx4 N/A
8Rx4 N/A
QRx4 32GB
QRx4 N/A
8Rx4 N/A
1
DRAM Density
8Gb 16Gb
8GB 16GB
16GB 32GB
16GB 32GB
32GB 64GB
2H-64GB 2H-128GB
4H-128GB 4H-256GB
64GB 128GB
2H-64GB 2H-128GB
4H-128GB 4H-256GB
* 4Gb DRAM density is only supported on speeds up to 2666MT/s.
- 13 -
2
Speed (MT/s); Voltage (V);
Slots per Channel(SPC) and
DIMM per Channel (DPC)
1 Slot Per Channel
1DPC
1.2V
2933
Hardware Installation