Qlima S5025 Operating Manual page 84

G
NOTE!
• In the AUTO mode, the air conditioner can logically choose the mode COOL, FAN and HEAT by
sensing the difference between the actual ambient room temperature and the set temperature
on the remote controller.
• If the AUTO mode is not comfortable for you , the desired mode can be selected manually.
COOL, HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY,
HEAT (HEAT PUMP units only), or FAN ONLY modes by pressing button .
2. Push the + or - button ( and ) to set the desired room temperature.
3. Push the Fan button  to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the On/off button . The operation lamp lights and the air conditioner starts to operate per your
settings. Push the On/off button  again to stop this unit operation.
G
NOTE!
The FAN ONLY mode cannot be used to control the temperature. In this mode, only steps 1, 3 and
4 are applicable.
DRY Operation
1. Push the Mode button  to select DRY.
2. Push the + or - button ( and ) to set the desired temperature.
3. Push the On/off button . The operation lamp lights and the air conditioner starts to operate in the DRY
mode. Push the On/off button  again to stop this unit operation.
G
NOTE!
Due to the difference of the set temperature of the unit and the actual indoor temperature, the
air conditioner when in DRY mode will automatically operate many times without running the
COOL and FAN mode.
TIMER Operation
Push Timer on/off button (i and j) to set the on and off times of the unit. The effective operation time set
by the remote controller for the timer function is limited to a period of between 0.5 and less than 24 hours.
1. To set the STARTING time.
1.1 Push the Timer on button i, then the remote controller display shows ON TIMER, the last set time for
the starting operation and the signal "h" will be shown on the Timer display area. You are now ready
to reset the time to START the operation.
1.2 Push the Timer on button i again to set desired unit start time.
1.3 After setting the Timer on ,there will be half a second delay before the remote controller transmits the
signal to the air conditioner.
2. To set the STOPPING time.
2.1 Push the Timer off button j and the remote controller display will show OFF TIMER and the last set
time for the timer off operation in hours will be shown on the Timer display area. You are now ready
to reset the time of the STOP operation.
2.2 Push the Timer off button j again to set the time you want to stop the operation.
2.3 After setting the Timer off, there will be half a second delay before the remote controller transmits the
signal to the air conditioner.
4
84