Maintenance - Stern Engineering PERFECT TIME SH Series Installation And Maintenance Manual

M A INTEN ANCE
This Perfect Time shower controls are provided with a stainless steel filter
preventing foreign particles to enter the lines. If the water flow has decreased,
this may be because the filter is clogged. The filter can be cleaned as follows:
Filter cleaning instructions for Perfect Time SH 1011:
1. Shut off the water supply.
2. Disassemble the shower faucet inlet from the water supply pipe.
3. Remove the filter and wash it under running water.
4. Reassemble the filter.
5. Reassemble the shower faucet inlet to the water supply pipe.
6. Turn on the water supply. Make sure that there is no water leakage.
Filter cleaning instructions for Perfect Time SH 1032 and 1032E:
1. Pull out the cover plate. Release the piezo cap's screw and carefully pull it out.
2. Shut off the valve using the 4 mm Allen key.
3. Unscrew the filter's cover and remove the filter.
4. Wash it under running water.
5. Reassemble the filter into the filter's cover.
6. Reassemble the filter's cover.
7. Open the valve and make sure that there is no water leakage.
8. Reassemble the piezo cap.
9. Reassemble the cover plate.
Care and cleaning of chrome and special finishes
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives,
or the like. Use of any prohibited cleaning or maintenance products or substances
could damage the surface of the shower control. For surface cleaning use ONLY
soap and water, then wipe dry with clean cloth or towel.
When cleaning bathroom tiles, the shower controls should be protected from any
splattering of harsh cleansers.
14