Viewing The Digital Signal Meter; Setting The Time Zone; Viewing The System Status; Reset Factory Defaults - Toshiba 19SL410U Owner's Manual

Viewing the digital signal meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1
Press u_u and open the Setup menu.
2 Highlight Installation and press @.
3 A new set of Installation menu icons will appear.
Open the Terrestrial menu, highlight Signal
Meter, and press @.
4 Press AIF_II_ to select the antenna input and
digital channel whose signal you want to check.
Note:
• The physical digital channel number listed in
the Signal Meter screen may not correspond to
a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
• The signal strength does not change between
virtual channels on the same physical channel.
To close the screen and return to the
Terrestrial menu:
Highlight Doneand press @.
To return to normal viewing:
Press
E_T
Setting the time zone
The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information (m_ page 50).
To set the time zone:
1
From the Setup menu, highlight Installation and
press @. A new set of Installation menu icons
will appear.
2 Highlight Time Zoge, and press @.
3 Press _ or _ to select the regiom highlight Doge,
and then press @.
After the time zone has been set, you will be asked to
set the current Daylight Saving Time status.
To set the Daylight Saving Time status:
1
Press a or I_ to select Yes or No, highlight Done,
and then press EN@.
Viewing the system status
To view the system status:
1
Press M_u and open the Setup menu.
2 Highlight Installatigg and press @.
3 A new set of Installation menu icons will appear.
Open the System Statusmenu, highlight System
Information, and press @.
4 Press ,Ior to scroll through the m enu bar to
select the Factory Defaults or Support
Information and view the related information.
To close the screen and return to the
Installation menu:
Highlight Doge and press @.
To return to normal viewing:
Press
E_T
Reset Factory Defaults
To reset all settings and channels to their
factory default values:
1
Press M_u and open the Setupmenu.
2 Highlight Installatiog and press @. A new set of
Installation menu icons will appear.
3
Open the SystemStatus menu, highlight System
Information, and press @.
4
Press _ or _" to scroll through the menu bar to
select Factory Defaults.
5 Highlight Yes and press @.
6 (If PIN code has been set, enter your PIN code.
Press _ or II_to select Doge and press @.) A
warning message will appear, select Yes and press
@, the TV will turn off automatically after a few
seconds. After the TV turns off unplug the TV
power cord and then plug it in again to complete
the reset process.
To cancel the reset:
Select No and press @
in step 5 above.
28