Adding And Clearing Channels And Inputs In The History List; Setting The Channel Tuning Mode; Tuning To The Next Progralmned Channel; Tuning To A Specific Channel (Progralmned Or Unprogralmned) - Toshiba 19SL410U Owner's Manual

In Select Mode, when you stop on an item in the
Channel Browser
TM,
it will be highlighted but you
must press @ to rune the TV to the highlighted
item.
2 Press @ to rune the TV to the highlighted item.
3 Press E_T to close the Channel Browser
TM.
Adding and clearing channels and
inputs in the History List
Adding channels and inputs to the History
List:
As a channel or input is tuned, the Channel
Browser
TM
adds it to the History List and displays it
on the "right side" of the Channel Browser
TM.
Previously tuned channels/inputs are "shifted" to the
• . • BACK
left, eventually moving off the left side. Press _ 4 to
surf backward through the previously tuned channels/
inputs. Any channel or input that is tuned repeatedly
will not be repeated in the History List, but instead is
moved to the end of the list on the right side of the
Channel Browser
TM.
The Channel Browser
TM
will store the following
channels:
• All channels that are tuned using the numeric
buttons on the remote control.
• All channels that are tuned using [_ or _ on the
remote control.
Note: Whenever an item is selected that cannot
be tuned (for various reasons), the TV will
automatically tune to the previously viewed
channel or input.
Clearing channels fl'om the History List:
• Reconfiguring
the ANT/CABLE input will clear the
History List.
Note: See page 24 for details on configuring the
antenna input.
• Once 32 channels or inputs are stored in the History
List, the oldest item will be removed from the list
when a new channel or input is tuned.
• Turning offthe TV will clear the History List.
Setting the Channel Tuning Mode
This feature allows you to choose how tuning will be
handled for analog and digital channels when the TV
is in Antenna mode.
Note: To use this feature, the Input
Configuration must be set to Antenna (_
page 24).
The channel tuning mode has three options.
Both analog and digital channels can be
Standard
tuned normally
Digital channels will have priority when
manually entering a channel number
Auto using the Channel Number (0-9) on the
(default) remote control, analog channels can still
be tuned by [_ / L_J, if available
Digital Only digital channels can be tuned
To set the Channel Tuning Mode:
1
From the Setup menu, highlight Installation and
press @. A new set of Installation menu icons
will appear.
2 Open the Terrestrial menu, highlight Chaonel
Tnniog Mode, and then press _" to select your
desired mode.
Note:
• The Channel Options windows as well as the
Channel Browser ANT/CABLE list will be
updated automatically when you change the
mode. Also, the History List will be cleared, but
the Favorites List will be saved.
• Even ff the Channel Tuning Mode is set to
Digital, analog channel 3 remains the default
channel in the event no digital channels were
found in prior channel scans. (Channel Options
will not have anything listed until a scan is
done.)
Tuning to the next programmed
channel
To tune to the next programmed channel:
Press [_ or L_J on the remote control or TV control
panel.
Note: This feature will not work unless you
program channels into the TV's channel memory
(_ page 24).
Tuning to a specific channel
(programmed or unprogrammed)
Tuning analog channels:
Press the Channel Number (0-9) on the remote
control. For example, to select channel 125, press 1,
2, 5, then @.
Tuning digital channels:
32