Table of Contents
Advertisement
6.1.4
Unit (Temperature unit)
You can select either degrees Centigrade of degrees as the unit for your temperature
measurement.
Press the MODE key until "UNIT" is displayed above the F1 key.
1.
2.
Press the F1 key.
Select "°C" for degrees Centigrade with the F2 key or "°F" for degrees Fahrenheit with
3.
the F3 key.
MEM (Memory) – viewing the saved readings
6.1.5
The thermometer saves the measured data including the time, date, emissivity and record no.
To view the readings:
Press the MODE key until "MEM" is displayed above the F2 key.
1.
2.
Press the F2 key.
3.
Use the F1 or F3 key to select a value from all the saved readings.
6.1.6
Emissivity
The pre-set standard value is 0.95. The standard value can be changed as follows:
Press the MODE key until "
1.
2.
Press the F3 key
To select a material from ths list, press F2 "Tab", make a selection from the list with F1
3.
and confirm with F2 "OK".
4.
To change the emissivity for other materials, increase the value with F1 or decrease it
with F3 (the values for some materials can be found in chapter 7).
6.1.7
Continuous measurement
To make a continuous measurement:
Press the MODE key until "
1.
2.
Press the F1 key. The
3.
To stop the continuous measurement, press the F1 key again.
6.1.8
Backlight
The backlight of the display has 8 brightness levels.
Press the MODE key until "Lit" is displayed above the F2 key. Then repeatedly press the F2 key
until the desired brightness is selected.
6.1.9
Laser
The thermometer is equipped with two lasers that mark the target point. The lasers are only
active during the measurement but can be disabled completely.
Press the MODE key until "Laser" is displayed above the F3 key.
1.
2.
Press the F3 key to enable or disable the laser. The laser icon will then appear or
disappear from the display.
6.1.10
Hi (Alarm for upper temperature limit)
When the upper temperature limit is exceeded, a continuous beeping sound can be heard.
Press the MODE key until "Hi" is displayed above the F1 key.
1.
2.
Press the F1 key.
3.
Press F1 to decrease the alarm limit, F2 to enable or disable or press F3 to increase
the alarm level.
" is displayed above the F3 key.
" is displayed above the F1 key.
icon will be displayed.
© PCE Instruments
7
Advertisement
Table of Contents
