INSTALLING THE SOFTWARE
:
N O T E
The ibutton must be
installed on the GL-1010
controller and you must
have a facsimile board
installed to the e-STUDIO
copier prior to installing
the GL-1010 fax software.
This information is
provided as an overview
only. For additional
information refer to the
GL-1010 Administrator's
Guide.
26
Overview
Before you can begin utilizing the Toshiba's optional Network
Fax Feature for the e-STUDIO GL-1010 systemyou must install
the software using the e-STUDIO GL-1010 Fax Client CD-ROM
provided. You will use the InstallShield client software setup
process.This section describes several
to user's workstations.
Address Book Editor software, the administrator must install
specific hardware and configure the fax options. Only authorized
users can modify the device.
Installing the GL-Fax Driver
CD Installation
Insert the e-STUDIO GL-1010 Fax Client CD-ROM into the
1
CD-ROM drive.
If AutoRun is enabled, the set-up program begins
2
automatically. If not, choose
then locate the Setup.exe file on the CD. Click
the setup program. The installation wizard leads you through
the process of installing the Fax Driver, Address Book and
TWAIN driver.
InstallShield Setup window
ways to add Fax Driver
Prior to installing the GL-Fax and
from the
Run
GL-1010 Network Fax Operator's Guide
Menu and
Start
to launch
OK