Table of Contents
Advertisement
3. Apply main AC Power first and then the 24 Volt DC Power to the Drive.
The Control Unit will recognize the card, and automatically load or overwrite the Data Set 0
to the Control Unit Non-Volatile memory. This procedure will only work for DataSet 0; no
other data sets will be affected.
S120 Display
The keypad will be shipped in a separate carton with Part Number:6SL3055-0AA00-4BA0,
which will have to be installed onto the Control Unit.
4. The data is read and loaded to memory prior to performing a Run-up sequence of the drive.
This procedure will take approximately 30 – 60 seconds longer at power up.
Note
When this step is complete, the display will register a F01650 fault.
This indicates that the drive is requesting an acknowledgement that the Emergency Stop
Safety circuitry has been checked and is working. This fault can be acknowledged by
pressing the
5. Once the fault has been cleared, the display will indicate a 0.0 value in the parameter/value
field
6. Once all necessary equipment has been connected and all sources of power applied for the
activation of the inputs and outputs, the drive unit should now be ready to activate.
– At this point, the WW100 may begin to move if the drive enables are set and if the Signal
– The application will be set for a maximum motor speed of 2500 RPM, approximately 50
SITRANS WW100
Operating Instructions, 06/2018, A5E33560618-AC
1
①
Drive number: there are two drive data sets, each with their own set of parameters.
● 01 = Command Data Set
● 02 = Drive Data Set
②
Parameter/value
● RUN mode
● EDIT mode
③
Function key
④
Parameter key
key.
②
; this is the actual RPM display of the motor.
Source voltage (i.e. Potentiometer) or the Analog input has a potential higher than zero
(0) volts!
FPM or 0.254 meters/second. Refer to P2000 - Maximum RPM (Page 17) to effectively
set the maximum RPM for the application.
4.2 Electrical installation for servo driven models
2
3
4
Installing
15
Advertisement
Table of Contents
