Declaration Of Conformity - Toshiba D-R160SB Owner's Manual

Declaration of Conformity

This product complies with the requirement of the
directives
EMC-Directive:
Low Voltage Directive:
CE Marking:
We declare that the following product:
DVD VIDEO RECORDER, Model D-R160SB
is in compliance with following Regulations.
EN55013: 2001+A1:2003, EN55020: 2002+A1:2003,
EN61000-3-2: 2000, EN61000-3-3: 1995 + A1: 2001
EN60065: 2002
EN60825-1 Edition 1.2: 2001
A NOTE ABOUT RECYCLING
This product's packaging materials are recyclable and
can be reused. Please dispose of any materials in
accordance with your local recycling regulations.
This product consists of materials
which can be recycled and reused if
disassembled by a specialised
company.
Batteries should never be thrown
away or incinerated but disposed of in
accordance with your local regulations
concerning chemical wastes.
Make your contribution to the environment!!!
• Exhausted batteries do not belong in the
dustbin.
• You can dispose of them at a collection
point for exhausted batteries or special
waste.
• Contact your council for details.
For Customer Use:
Carefully read the Model No. and Serial No. located at
the back of the unit and enter the information below.
Retain this information for future reference.
Model No.
Serial No.
89 / 336 / EEC
73 / 23 / EEC
93 / 68 / EEC
Connection to Power
Before Switching on make sure that the voltage of your
electricity supply is the same as that indicated on the
rating plate.
Mains Cord
This appliance may be fitted with a non-rewireable plug.
If it is necessary to change the fuse in a nonrewireable
plug the fuse cover must be refitted. If the fuse cover is
lost or damaged, the plug must not be used until a
replacement available from the appliance manufacturer
is obtained.
It is important that the colour of the replacement fuse
cover corresponds with the rating marking on the base
of the plug.
If the plug has to be changed because it is not suitable
for your socket, or becomes damaged, it should be cut
off and an appropriate plug fitted following the wiring
instructions below. The plug removed must be disposed
of safely as insertion into a 13A socket is likely to cause
an electrical hazard.
For your own safety read the following instructions
carefully before attempting to connect this unit to mains.
The wires in this mains lead are coloured in accordance
with the following code:
BLUE=NEUTRAL, BROWN=LIVE
Important
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows:-
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or coloured
red.
No connection is to be made to the earth terminal of the
plug.
If a 13 Amp (BS 1363) Plug is used, a 3 Amp Fuse must
be fitted, or if any other type of Plug is used a 3 or 5
Amp Fuse must be fitted, either in the Plug or Adaptor,
or on the Distribution Board.
Mains Supply:220 - 240V 50 Hz - AC only
Do not make any connection to the larger pin marked
with the letter "E" or by the symbol
or green and yellow.
BLUE
(Neutral)
OUTER SHEATH OF THE WIRE
or coloured green
FUSE
BROWN
(Live)
CORD GRIP
EN 3