Table of Contents
Advertisement
Transport with crane
Only those cranes, load attachment devices, rigging, etc.
may be used for the transport of equipment components,
which are suitable and approved.
The lift rig must not be able to damage the assembly.
The crane eye-lugs prescribed for transport by crane are to
be used only up to their specific weight limit. For larger or
heavier pieces of equipment, base frame eye-lugs should
be used. Check to determine if the crane eye-lugs have
loosened during transport. The crane eye-lugs must be
securely threaded to their stops.
The crane eye-lugs on outdoor units must not be
removed, otherwise water proofness of the roof can not
be guaranteed.
For all other installations, where the crane eye-lugs are
removed, the delivered packings should be mounted. Also
by two-sections units, the packings should be mounted on
the lower section.
With crane transport, the attachment angle must not be
less than 60°. As an alternative, cross-beams can be used.
The load must be symmetrically distributed in order to
prevent slipping or tipping.
Lifting from the transport vehicle or the ground must be
undertaken slowly and carefully. Jerking movement must
be avoided.
6
www.swegon.com
Transport with hand lift truck
When transporting with a hand lift truck the forks must
completely underlie the assembly components to be
transported. In the event the equipment is larger than the
hand lift truck, a second hand lift truck/forklift should be
used for transport.
Transport on iron rail/wood beams
It must be ensured that the equipment profile is securely
positioned on the transport devices.
The transport media support surface must not be able to
cause damage to the equipment.
The company reserves the right to make design changes without prior notice.
EN.SILVER.110322
Advertisement
Table of Contents
