Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for Danfoss Akva Lux II TDP Reno
Summary of Contents for Danfoss Akva Lux II TDP Reno
- Page 1 Instructions for installation and use District heating substation for exhange of Gas Boilers Akva Lux II TDP Reno District district heating substation for heating and domestic hot water. Reno Exchange of gas boilers. www.danfoss.com...
-
Page 2: Table Of Contents
7.0 Getting started ............................................7 8.0 Installation instructions, General .......................................8 8.1 Height adjustable cover ......................................12 Adjustment and commissioning of the Akva Lux II TDP RENO ........................... 13 10.0 Maintenance............................................15 10.1 Maintenance schedule (recommendations) ..............................16 11.0 Troubleshooting, Heating........................................17 12.0 Troubleshooting, Domestic hot water .................................. -
Page 3: Product Introduction
The control function, however, is basically as stated in this instruction manual. Instructions for the fitted components will be supplied together with the substation. Connections size: DH, HE, DHW, DCW: G¾” IT Supply Return VI.JV.R1.02 3 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... -
Page 4: Dimensional Sketches / Connections
H 1130/1140 x W 480 x D 150 mm Please note that the cover is adjustable by 100 mm in height. Please refer to page 12 for more infor- mation. 480 mm VI.JV.R1.02 4 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... -
Page 5: Enduser Instructions, General
90°C and the operating pressure can be up to 10 bar. This may result in a risk of scalding from touching the Akva Lux II TDP RENO is designed for wall mounting. For this purpose substation and from outflow of the medium (water/steam). Ex-... -
Page 6: Enduser Instructions, Initial Adjustment/Setting
We suggest that you contact your local plumber for assistance Heating circuit, temperature control The room temperature is regulated exclusively using the radiator thermostats. AVPL VI.JV.R1.02 6 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... -
Page 7: Installation Instructions, Safety And Handling
Close all energy sources and disconnect all connection pipes. Disconnect and dismantle the product for disposal in accordance with the applicable local regulations for the disposal of the individual components. VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 7... -
Page 8: Getting Started
12. Finish by adjusting the substation in accordance with this instruction manuals. WICHTIG! Erwärmung und Abkühlen der Wohnungsstation kann Leckagen verursachen. Deshalb kann Nachziehen alle Verschraubungen und Anschlüsse nach der Inbetriebnahme notwendig sein. VI.JV.R1.02 8 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... - Page 9 DH supply and return and a microprocessor calculator for the calculation of energy consumption. On the LCD display of the calculator the energy consumption can be read. VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 9...
- Page 10 - Fit the cold water meter, - remember to insert gaskets. - After mounting of cold water meter remember to check and tighten all pipe connections before commissioning the cold water meter(s). VI.JV.R1.02 10 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03...
- Page 11 The water pressure in the system remains constant. (Please note that the anti-water hammer tank is not included in the delivery). VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 11...
-
Page 12: Height Adjustable Cover
The Akva Lux II TDP RENO substations are designed for wall mounting. Fig. 1 Fig. 1a Akva Lux II TDP RENO is designed for wall mounting. For this purpose it is fitted with a height-adjustable cover made of white painted sheet steel. -
Page 13: Adjustment And Commissioning Of The Akva Lux Ii Tdp Reno
Fig.. 2 By-pass function (factory connection). The Akva Lux II TDP-F substations are supplied with the a Danfoss FJVR by- pass thermostat (Fig. 2), so that when water is tapped, the water heater immediately starts to produce hot water. We re-commend setting of the thermostat in pos. - Page 14 To keep cor- rect temperature and friendly microclimate for human beings in the apartment, it is recommended to ensure regular airing in rooms. VI.JV.R1.02 14 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03...
-
Page 15: Maintenance
This will remove any dirt deposits that may have built up in the exchanger. If rinsing with clean water is not sufficient, the exchanger can also be cleaned by circulating a cleaning agent approved by Danfoss (e.g. Kaloxi or Radiner Fl cleaning fluid) through the exchanger. Both these cleaning fluids are environmentally friendly and can be disposed off through the standard sewer system. -
Page 16: Maintenance Schedule (Recommendations)
Check the functions of all shut-off valves Check that the ball valves open and close as they should IMPORTANT! Replace gaskets after separation of parts VI.JV.R1.02 16 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... -
Page 17: Troubleshooting, Heating
Poor cooling requirement of the building Poor utilization of existing heating Turn on all the radiators and prevent the surface radistors in the system from becoming VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 17... -
Page 18: Troubleshooting, Domestic Hot Water
Plate heat exchanger short-circuited. Replace the plate heat exchanger. period) Replace the plate heat exchanger or Lack of hot water pressure Calified plate heat exchanger. clean it with acid. VI.JV.R1.02 18 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... -
Page 19: Eu Declaration Of Conformity
Instructions for installation and use Akva Lux II TDP RENO 13. EU DECLARATION OF CONFORMITY VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 19... -
Page 20: Commissioning Certificate
Over-tightening may result in leaks. Leaks caused by ove-rtightening or failure to retighten connections are not covered by the warranty. To be filled-out by the installer This substation has been retightened, adjusted and commissioned on the: by installer: Date/Year Company name (stamp) VI.JV.R1.02 20 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03... - Page 21 Instructions for installation and use Akva Lux II TDP RENO VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 21...
- Page 22 Instructions for installation and use Akva Lux II TDP RENO VI.JV.R1.02 22 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03...
- Page 23 Instructions for installation and use Akva Lux II TDP RENO VI.JV.R1.02 © Danfoss | Produced by Danfoss Redan A/S | 2015.10 | 23...
- Page 24 Danfoss Redan A/S · District Energy · Omega 7, Søften · DK-8382 Hinnerup Tel. +45 87 43 89 43 · Fax: +45 87 43 89 44 · redan@danfoss.com · www.redan.danfoss.dk VI.IQ.L1.02 24 | © Danfoss | Produced by Danfoss Redan A/S | 2016.03...
Need help?
Do you have a question about the Akva Lux II TDP Reno and is the answer not in the manual?
Questions and answers