Page 1
Instructions for installation and use Indirect, fully insulated district heating substation VXe Solo HT District heating substation for indirect heating and connection pipes for domestic hot water. Solo HT Fully insulated for high or low temperature district heating networks. www.danfoss.com...
Page 4
VXe Solo HT INSTALLATION INSTRUCTIONS, SAFETY AND HANDLING Reach All products of the VXe Solo HT series comply with the provisions of the REACH regulation. We are therefore obliged to inform our customers about the presence of substances according to the SVHC candidate list, if they are present.
For fully insulated systems The insulation front panel on the VXe Solo HT substations can be removed without using tools. Take hold of the air duct in the top and bottom of the front insulation section and pull carefully forward until the front insulation section releases from the rear section.
Actuator and valve, VXe Solo HWP HT For controlling the heating circuit the VXe Solo HWP HT is supplied with a Danfoss AMV 150 / AMV 13 actuator and a Danfoss two-way motorized contral valve VM 2, placed on the primary return ow line.
Use is not recommended * Hardness ration limits defined per experience and internal tests in Danfoss laboratory ** In case of three or more parameters evaluated with o consultancy is needed with Consultant for Corrosion & Microbiology or BU HHE Representative...