Keithley 7015-S Instruction Manual page 8

40-Channel Solid State Multiplexer Cards
MULTIPLEX CONFIGURATION: Four independent 1×10 2-pole
multiplex banks or two independent 1×10 4-pole multiplex banks.
Adjacent banks can be connected together. Jumpers can be removed to
isolate any bank from the backplane.
CONTACT CONFIGURATION: 2-pole Form A (Hi, Lo).
CONNECTOR TYPE:
7015-C: 96-pin male DIN connector.
7015-S: Screw terminal, #16AWG maximum wire size, with .092 inch
O.D. 28 conductors per card maximum. #22AWG typical wire size
with .062 inch O.D. 88 conductors per card maximum.
MAXIMUM SIGNAL LEVEL: 175V peak between any two pins, 34mA
resistive load, 0.3VA max., 1 × 10
COMMON MODE VOLTAGE: 175V peak, any pin to chassis.
CONTACT TYPE: Solid state switch.
CHANNEL RESISTANCE (per conductor): < 210Ω.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Model 7015-C, 7015-S
6
V•Hz max.
Bank A
H I
Channel 1
LO
Channels 2-9
H I
Channel 10
LO
Banks B-C
Bank D
H I
Channel 1
LO
Channels 2-9
H I
Channel 10
LO
CONTACT POTENTIAL:
7015-C:<5µV per channel contact pair.
7015-S: <4µV per channel contact pair.
OFFSET CURRENT: < 1nA.
ACTUATION TIME: <500µs.
ISOLATION:
Ω, <25 pF.
9
Bank: >10
Ω, <50 pF.
9
Channel to Channel: >10
Differential: Configured as 1×10: >10
Configured as 1×40: >10
Common Mode: Configured as 1×10: >10
Configured as 1×40: >10
INSERTION LOSS (50Ω Source, 1MΩ Load): <0.1dB below 250kHz,
<3dB below 500kHz.
ENVIRONMENT: Operating: 0° to 50°C, up to 35°C at 80% RH.
Storage: –25°C to 65°C.
Specifications subject to change without notice.
J
H I
H I
J
Output
LO
LO
J J
J J
J
H I
H I
J
Output
LO
LO
Ω, <100pF.
9
Ω, <200pF.
9
Ω, <375pF.
9
Ω, <1100pF.
9
Backplane
Backplane