General Information; Introduction; Features; Warranty Information - Keithley 7015-S Instruction Manual

1.1

Introduction

This section contains general information about the Model
7015 40-Channel Solid-State Multiplexer Card.
There are two basic versions of this multiplexer card; the
Model 7015-S and the Model 7015-C. The Model 7015-S as-
sembly consists of a screw terminal connector card and a re-
lay card. External test circuits are wired directly to the screw
terminals of the connector card. Also available from Keithley
is the Model 7015-ST, which is an extra screw terminal con-
nector card. With an extra connector card, you can wire a
second test system without disturbing the wiring configura-
tion of the first test system.
The Model 7015-C assembly consists of a multi-pin (mass
termination) connector card and the relay card. External test
circuit connections to the multiplexer are made via the 96-
pin male DIN connector on the connector card. Keithley of-
fers a variety of optional accessories that can be used to make
connections to the connector card (see paragraph 1.8).
The rest of Section 1 is arranged in the following manner:
1.2

Features

1.3

Warranty information

1.4 Manual addenda
1.5 Safety symbols and terms
1.6 Specifications
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

General Information

1.7 Unpacking and inspection
1.8 Repacking for shipment
1.9 Optional accessories
1.2 Features
The Model 7015 is a solid-state, two-pole, quad, 1 × 10 mul-
tiplexer card. Some of the key features include:
• Solid-state relays for fast switching, indefinite "con-
tact" life, and quiet operation.
• Low contact potential and offset current for minimal ef-
fects on low-level signals.
• The connector board detaches from the relay board al-
lowing easy access to the screw terminals (Model 7015-
S) and jumpers.
• Easy jumper configuration of one, two, three or four
multiplexer banks.
• Backplane jumpers. Cutting jumpers disconnects multi-
plexer bank outputs from the Model 7001 or Model
7002 analog backplane.
1.3 Warranty information
Warranty information is located on the inside front cover of
this instruction manual. Should your Model 7015 require
warranty service, contact the Keithley representative or au-
thorized repair facility in your area for further information.
1
1-1