Cleaning The Brushroll; Cleaning The Soft Roller; Checking The Nozzle For Blockages - Shark DuoClean Powered Lift-Away NZ801UK Series Instructions Manual

MAINTENANCE - CONT�
Anti-Hair Wrap Technology
TIP: You can also check
for blockages in the hose
Anti-Hair Wrap Technology actively removes hair wrap from
and airways. Just remove
your brushroll while you vacuum. If you run over a hard or sharp
the floor nozzle, dust cup,
object or notice a noise change while vacuuming, check for
and hose and shine a
blockages or objects caught in the brushroll.
torch in the openings.
If you see any hair
NOTE: Do not be alarmed if there is visible hair at any given
wrapped around the
time, as it will eventually make its way to the dust cup.
brushroll, continue
cleaning, using Carpet/
Low Pile mode on hard
floors. This will allow the
Anti Hair Wrap technology
to remove the hair wrap
and send it to the dust
cup.

CLEANING THE BRUSHROLL

1 Use a coin to unlock the 3 locks on the bottom of the floor
nozzle, a portion of the base is removable to allow for better
access to the brush roll and exposure to the airway. Shine a torch
from the bottom to check for possible blockage in the airway.
2 Clear away any objects or debris.
3 To reassemble, replace base by lining it up along the front of
the nozzle. Push down to snap into place. Lock the 3 locks.
17
0800 862 0453
STEP 1
DuoClean Technology
®
DuoClean Technology features a bristle brush to deep-
®
clean carpets, and an additional soft brushroll to pull in larger
particles and directly engage floors for a polished look. With
normal use, you may need to perform routine maintenance of
your Soft Roller. See the instructions below.

CLEANING THE SOFT ROLLER

1 To remove Soft Roller from nozzle, lift it out
pulling the tab on the right side.
2 Tap loose debris off the Soft Roller. Use a
dry towel to wipe the Soft Roller clean, or
to remove any debris caught in the teeth
behind the Soft Roller.
3 Hand-wash the Soft Roller as needed. Use
only water, and let air-dry completely for at
least 24 hours.
4 Reinsert Soft Roller under rubber bumper in
front of nozzle until it clicks into place.

CHECKING THE NOZZLE FOR BLOCKAGES

Tilt neck of nozzle back to straighten the
1
airway, then remove any blockages.
s h a r kc l e a n . e u 18