Operation - WAGNER CONTROL PRO Owner's Manual

oPeration

1. Make sure the arrow on the tip handle is pointing in the forward direction
for spraying.
2. Start the sprayer. Refer to the instructions in the sprayer's Owner's Manual.
3. Adjust the fluid pressure on the sprayer until the spray is completely
atomized. Always spray at the lowest pressure necessary to get the desired
results.
The spray tip determines the size of spray pattern and coverage.
i
When more coverage is needed, use a larger tip instead of increasing
fluid pressure.
4. To clear a clogged tip:
a. Rotate the tip 180º so that the arrow on the tip handle is pointing opposite the
spray direction.
b. Trigger the gun once so that the pressure can blow the clog out.
cHanGinG a tiP
Tips can be removed and replaced easily without disassembling the gun.
Never attempt to change or clean the tip or tip guard without first
performing the "Pressure Relief Procedure."
1. Perform the "Pressure Relief Procedure" described in the sprayer's Owner's
Manual.
2. Remove the tip from the slot on the tip guard.
3. Insert the new tip into the slot on the tip guard. The arrow on the tip handle
should be pointing in the forward direction for spraying.
removinG tHe Seal anD tiP Seal
1. Remove the tip (1) from the tip guard (2).
2. Insert the tip handle through the front of the
tip guard.
3. Push the tip seal (3) and tip seal retainer (4)
out through the back of the tip guard.
1
2
3
4
7