Table of Contents
Advertisement
4.6 Notes When Using
(1) Auto setting
Windows95's "Auto Insert Notification", "Auto Run" and "Auto Play" automatically execute the specified
operations when a disc is loaded or unloaded. However, with some CDs - especially music CDs - are
used, the disc may be switched unnecessarily. To prevent this, the auto settings are automatically
disabled when the TEAC device driver is installed in the multi-drive mode. To enable these functions,
use the Changer Assistance Utility.
When it is installed in the signal drive mode, the number of disc changes in the drive can be decreased
even when all automatic settings are enabled.
Note: To decrease the number of disc changes when the Auto Insert Notification is enabled in the multi-
drive mode, do not insert a disc in the arbitrary slot until it is required. This method can be also
used to shorten the start-up time of the microcomputer.
(2) MCICDA DRV
When CDP is installed in Windows 3.1, the SYSTEM.INI (normally located in the directory in which
Windows is installed) is changed as shown below to allow playback in all slots.
Before change : CDAudio = MCICDA.DRV
After change
: CDAudio = MCICDA.DRV0
CDAudio1 = MCICDA.DRV1
CDAudio2 = MCICDA.DRV2
CDAudio3 = MCICDA.DRV3
CDAudio4 = MCICDA.DRV4
CDAudio5 = MCICDA.DRV5
If you have any operational problems after installation, restore the setting before changing.
(3) Changer Assistance Utility
The Changer Assistance Utility lets you edit various registry key data.
Do not forcibly interrupt key data editing (e.g. reset) as this may delete the registry. Be sure to
back up the registry before editing the data.
We are not responsible for inadvertent loss or destruction of the registry caused by executing this
utility or for any errors which make restart impossible.
(4) Drive letter
If the device driver is not installed properly, only one drive letter may be displayed even in the multi
-drive mode. In this case, click System in the control panel to check the property in the device
manager(hard disc controller).
Also, if the changer drive is used in a system which users (or has used) a CD-R drive, only one drive
letter may be displayed even in the multi-drive mode. Contact your CD drive manufacturer or dealer
if you have any problems.
(5) Enhanced CD
Most enhanced CDs such as CD-Extra are not designed with changers in mind. As a result, these
types of CDs may not operate normally in the changer drive. For best results, always be sure to insert
enhanced CDs in Slot 1. If you still have problems, contact your CD manufacturer or dealer.
Advertisement
Table of Contents
