SETTING UP THE BASE UNIT (WALL MOUNTING)
MOUNTING ON A STANDARD WALL PLATE:
Insert the bracket's tabs into the
base's lower tab slots, then press
down on the top of the bracket to
snap it into the clip slots.
Flip the switch hook
tab over so the tab
holds the handset.
• Route the cords through the guides.
• Place the base unit on the posts of the wall plate and push down until it is
firmly seated.
• USE ONLY WITH Supplied AC ADAPTOR (TAC-1700; power source AC
120V, 60 Hz/DC 9V).
NOTES:
• Do not use any outlet controlled by a wall switch.
• If you don't have a standard wall plate, cut out the template on page 33 and
use it to position two screws (minimum length of 1
with the heads protruding about
INSTALLATION
Raise the antenna.
Telephone Line Cord
AC Adaptor
/
inch.
1
4
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120 V, 60 Hz)
3
/
inches) into the wall
8
11