Setting Up The Base Unit (Wall Mounting); Wall Mount Template - Toshiba SG-1981 Owner's Manual

SETTING UP THE BASE UNIT (WALL MOUNTING)

MOUNTING ON A STANDARD WALL PLATE:
Insert the bracket's tabs into the base's lower
tab slots, then press down on the top of the
bracket to snap it into the clip slots.
Flip the hook tab over
so the tab holds the
handset.
• Route the cords through the guides.
• Place the base unit on the posts of the
wall plate and push down until it is firmly seated.
NOTES:
• Do not use any outlet controlled by a wall switch.
• If you don't have a standard wall plate, cut out the template on this page and
use it to position two screws (minimum length of 1
with the heads protruding about
CUT
•
•
Raise the antenna.
1 /
4

Wall mount template

IMPORTANT:
Before mounting, select a wall area of sufficient
strength. If mounting on wallboard or in an area
of questionable strength, locate a stud for
maximum support of your telephone.
Avoid electrical cables, pipes, or other items
behind the mounting location that could cause a
hazard.
INSTALLATION
AC Adaptor
3 / inches) into the wall
8
inch.
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120 V, 60 Hz)
CUT
11