Troubleshooting - Toshiba SG-1600 Owner's Manual

TROUBLESHOOTING

Should any problem occur with the set, use the following simple tests to determine
whether or not servicing is required.
PROBLEM
No dialtone.
No calls come in.
Noise or interference.
Battery pack goes low
quickly.
36
• The AC adaptor of the base unit is disconnected.
→ Plug the AC adaptor into the base unit and the AC
120V outlet.
• The battery is low.
→ Place the handset on the base unit to recharge.
• Telephone line cord is disconnected.
→ Check both ends of the telephone jack.
• The previous call is not disconnected.
→ Press
to disconnect the line.
TALK
• Trouble with the telephone line.
→ Check an extension line.
• Outlet used is controlled by a wall switch in its OFF
position.
→ Relocate it to another outlet.
• The digital security code is changed.
→ Disconnect the power and remove the handset. After a
few seconds, restore the power and place the handset
on the base unit for at least 3 seconds.
• The handset is too far from the base unit.
→ Bring the handset near the base unit.
• The handset is too far from the base unit.
→ Bring the handset near the base unit.
• The battery is low.
→ Place the handset on the base unit to recharge.
• The base unit is located in a place with high interference.
→ Relocate it to another outlet.
• Interference from TV, appliances, etc.
→ Press
CHANNEL
the base unit.
• There may be line noise.
→ Check with another telephone.
• The volume control is set too high.
→ Reduce volume to a lower setting.
• The base antenna is not in a vertical position.
→ Lift the antenna to a vertical position.
• The battery pack was not fully charged at the initial
charging.
→ Charge the battery pack for 12 to 16 hours without any
interruption.
• The battery is several years old
→ Replace with a new battery
SOLUTION
to select a clearer channel, or relocate