Table of Contents
Advertisement
You may use either the left or right channels for sending and receiving monaural
audio to the VSX 8000. For stereo operation, both the left and right channels must be
used.
Please follow our instructions for wiring the Vortex device to the codec (See the
section W
IRING FROM
ground noise into the signals sent and received from the codec.
E
NABLING THE
D
EVICE
1. Connect a video monitor to Video Output 1 of the codec.
2. On the VSX 8000 User Interface, go to S
N
for Page 2. Select the L
EXT
3. (Optional) Enable the VSX 8000 to control the Vortex Device by setting Serial Port 1 or
Serial Port 2 to Vortex Mixer. In the VSX 8000 User Interface, go to S
S
, G
ETTINGS
ENERAL
RS-232 Mode. Verify that the baud rate of the VSX 8000 matches the baud rate of the
Vortex Device. See the page C
information.
4. Once that is completed, make sure that the Codec Input to the Vortex Device is assigned
to the appropriate AEC Reference signal if the VSX 8000 will be used in Mono mode
(Standard AEC Operation). If using InstantDesigner to create the configuration settings
for the Vortex, the reference will be set automatically. For Stereo Mode, please refer to
the S
AEC O
TEREO
VSX 8000
V
TO
ORTEX
VSX 8000
I
option for the Input Type. Set the Level setting to 5.
INE
NPUT
S
, S
P
ETTINGS
ERIAL
ORTS
ONTROLLING A
section.
PERATION
D
). Failure to do so may induce him and
EVICE
TO WORK WITH A
, A
S
YSTEM
DMIN
ETTINGS
. For the appropriate port, select V
V
D
ORTEX
EVICE VIA THE
V
ORTEX
, A
S
, and select
UDIO
ETTINGS
, A
YSTEM
DMIN
M
ORTEX
VSX8000 for more
for
IXER
6
Advertisement
Table of Contents
