Advertisement
2 Please read this first
Before connecting and using the device, first check that everything has been supplied and familiarize yourself
with the safety instructions.
The following should be included:
1 Digital receiver, 1 Remote control, 1 Quick start operation manual, 1 CD-ROM,
2 Batteries (1.5V micro-cell), 1 HDMI cable, 1 mains cable.
2.1 Safety advice
For your own protection, you should read the safety precautions carefully before using your new receiver.
The manufacturer accepts no liability for damage caused by inappropriate handling, or by non-compliance
with the safety precautions.
Function-related discharge current may occur with electrical equipment. This is acceptable and poses
no risk, even if it is experienced as a slight tingling.
To prevent these discharge currents, mains operated devices (receivers, TVs, etc.) must always be
installed or connected with the power switched off, i.e., devices must be disconnected from the mains
power supply.
-
Only operate the receiver in a temperate climate.
-
To ensure adequate ventilation, place the receiver on a flat, horizontal surface and do not place any
objects on top of it. There are ventilation slots here to allow heat to be dissipated from the interior
of the unit.
-
Do not place any burning objects, such as lit candles, on top of the receiver.
-
Do not expose the receiver to water droplets or water spray, and do not place any objects filled with
liquid, such as vases, on top of it. If water gets into the unit, immediately disconnect the mains plug
and inform the service department.
-
Do not operate any sources of heat near the unit, which may also heat it up.
-
Do not obstruct the ventilation slots.
4
Advertisement
