Lifted Height Of Outer Front Cutting Units; Travel Of Front Three Cutting Units - Toro Reelmaster 6500–D Service Manual

Lifted Height of Outer Front Cutting Units (Enable Position)
The turnaround height of the front outer cutting units (#4
& #5) may be increased to provide additional ground
clearance on contoured fairways. Contact your distribu-
tor for assistance.

Travel of Front Three Cutting Units

Additional downward travel of the front three cutting
units may be desirable in highly contoured locations. If
any of the front three cutting units lift off the ground when
cresting a "hill", the front carrier frame may be lowered
by removing mounting bolts and repositioning frame in
the bottom set of holes in the main frame (Fig. 36). Con-
tact your distributor for assistance.
Note: Moving the carrier frame down will decrease the
amount of clearance between the cutting units and the
ground in turnaround and transport positions and may
require adjusting the lift chain length on the cutting unit.
Cutting Units Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up
1
1. Carrier frame mounting bolts
Page 8.1 – 20 Rev. C
Figure 36
Reelmaster 6500–D/6700–D