Toro Reelmaster 6500–D Service Manual page 6

7. Remove all debris or other objects that might be
picked up and thrown by the reels or fast moving compo-
nents from other attached implements. Keep all by-
standers away from operating area.
8. Since diesel fuel is highly flammable, handle it careful-
ly:
A. Use an approved fuel container.
While Operating
9. Sit on the seat when starting and operating the ma-
chine.
10. Before starting the engine:
A. Engage the parking brake.
B. Make sure traction pedal is in NEUTRAL, throttle
is in SLOW and the ENABLE / DISABLE switch is in
DISABLE.
C. After engine is started, release parking brake and
keep foot off traction pedal. Machine must not
move. If movement is evident, the neutral return
mechanism is adjusted incorrectly; therefore, shut
engine off and adjust until machine does not move
when traction pedal is released.
11. Seating capacity is one person. Therefore, never
carry passengers.
12. Do not run engine in a confined area without ade-
quate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
13. Check interlock switches daily for proper operation.
If a switch fails, replace it before operating the machine.
The interlock system is for your protection, so do not by-
pass it. Replace all interlock switches every two years.
14. Using the machine demands attention and to pre-
vent loss of control:
A. Operate only in daylight or when there is good ar-
tificial light.
B. Drive slowly
C. Watch for holes or other hidden hazards.
D. Look behind machine before backing up.
E. Do not drive close to a sand trap, ditch, creek or
other hazard.
F. Reduce speed when making sharp turns and
turning on a hillside.
Safety
B. Do not remove fuel tank cap while engine is hot or
running.
C. Do not smoke while handling fuel.
D. Fill fuel tank outdoors and only to within an inch of
the top of the tank, not the filler neck. Do not overfill.
E. Wipe up any spilled fuel.
G. Avoid sudden stops and starts.
15. Traverse slopes carefully. Do not start or stop sud-
denly when traveling uphill or downhill.
16. Operator must be skilled and trained in how to drive
on hillsides. Failure to use caution on slopes or hills may
cause loss of control and vehicle to tip or roll possibly re-
sulting in personal injury or death. On 4 wheel drive
model, always use the seat belt and ROPS together.
17. If engine stalls or loses power and cannot make it to
the top of a slope, do not turn machine around. Always
back slowly straight down the slope.
18. DON'T TAKE AN INJURY RISK! When a person or
pet appears unexpectedly in or near the mowing area,
STOP MOWING. Careless operation, combined with
terrain angles, ricochets, or improperly positioned
guards can lead to thrown object injuries. Do not resume
mowing until area is cleared.
19. Do not touch engine, muffler or exhaust pipe while
engine is running or soon after it is stopped. These
areas could be hot enough to cause burns.
20. If cutting unit strikes a solid object or vibrates abnor-
mally, stop cutting units immediately, turn engine off, set
parking brake and wait for all motion to stop. Inspect for
damage. If reel or bedknife is damaged, repair or re-
place it before operating. Do not attempt to free blocked
cutting unit by reversing reel direction. Damage to reel
may result.
21. Before getting off the seat:
A. Move traction pedal to neutral.
B. Set parking brake.
C. Disengage cutting units and wait for reels to stop.
D. Stop engine and remove key from switch.
E. Do not park on slopes unless wheels are chocked
or blocked.
Page 1 – 2 Rev. B
Reelmaster 6500–D/6700–D