Set-Up And Adjustments - Toro Reelmaster 6500–D Service Manual

Set–up and Adjustments
IMPORTANT: Toro strongly recommends the use of a
leveling plate when setting–up or adjusting any reel type
cutting unit. The leveling plate will help to ensure accu-
rate and consistent adjustments.
Note: Right and left ends of cutting unit is determined by
standing in the operator's position (Fig. 7).
Use the following sequence to set–up and adjust each
cutting unit:
1. Check each end of the reel for grease. Grease should
be visibly evident in the reel bearings and internal
splines of reel shaft.
2. Insure that all nuts and bolts are securely fastened.
3. Make sure 4 bar link suspension operates freely and
does not bInd when moved back and forth.
4. Adjust bedknife to reel.
5. Adjust and level front and rear rollers.
6. Set height–of–cut.
Reelmaster 6500–D/6700–D
RIGHT
Page 7 – 7 Rev. B
LEFT
Figure 7
Cutting Units
Model 03853
Model 03854
Model 03855