Adjusting The Lifted Height; Of The Outer Front Cutting Units (Enable Position); Cutting Units (Enable Position) - Toro 03540 Reelmaster 5200-D Operator's Manual

spring bracket and front of the washer is 1.25
inches (3.2 cm) (Figure 13).
2. Tighten the hex nuts on the front end of the
spring rod until the compressed length (A) of
spring is 6.25 inches (32.8 cm) (Figure 13).
As the compressed spring length (A)
decreases, weight transfer from the front
roller to the rear roller increases and the
carrier frame/cutting unit rotation angle (B)
decreases.
As the gap (C) between the spring bracket and
washer increases, the carrier frame/cutting
unit rotation angle (B) increases.
Step
7

Adjusting the Lifted Height

of the Outer Front Cutting
Units (Enable Position)
No Parts Required
Procedure
The turnaround height of the front outer cutting
units (#4 & #5) may be increased to provide
additional ground clearance on contoured fairways.
Note: The RM CONFIG time delay should not
be changed from the original setting of 0 when
using this method to adjust turn around height.
To increase the turn around height of the front
cutting units proceed as follows:
1. Position the machine on a level surface, lower
the cutting units, and stop the machine.
2. Loosen the carriage bolt nut securing the lift
arm switch bracket to the No. 4 lift arm (left
front) (Figure 14).
Figure 14
1. Lift arm switch
2. Carriage bolt nut
3. Move the lift switch bracket inward in the slot
until the desired position is attained.
4. Set the distance between the lift arm switch
and the flag on the lift arm to approximately
0.062 inches (1.6 mm).
5. Tighten the carriage bolt nut.
19
3. Lift arm ag