Specifications - Toro Reelmaster 6500–D Service Manual

Specifications

Reel Construction: Fairway reels. All welded. 5, 7 or 11
blades.
Height Of Cut Range:
5 Blade – 3/4" to 1–1/2" (19–38 mm)
7 Blade – 1/2" to 1–1/8" (13–29 mm)
11 Blade – 3/8" to 3/4" (10–19 mm)
NOTE: Use bedknife Part No. 93–9774 for height–of–
cuts below 1/2" (13 mm).
Reel Diameter: 7 in. (178 mm)
Power Attachment: Reel motors feature quick discon-
nect for removal or installation onto cutting unit. Cutting
units can be driven from either end.
Height–of–cut & Roller Adjustment: Height–of–cut
adjustment is made at the rear roller with quick locating
pin and/or threaded micro–adjustment. Front roller posi-
tion is adjustable to set cutting unit attitude.
Bedknife And Bedbar Adjustment: Single point ad-
justment (SPA) mechanism.
Cutting Units Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up
Figure 1
Clip Frequency: .375" – 1.25" (10–32 mm).
Automatic Clip Control: The Reelmaster 6000D Se-
ries Traction Unit is equipped with an electronic control-
ler which is programmed to achieve automatic clip
control.
As the traction unit speed varies, the controller will auto-
matically adjust the hydraulic flow to the reel motors to
vary reel speed and maintain proper clip.
For proper clip, the controller needs to know what cut-
ting units are installed (5, 7 or 11 blade) and the height–
of–cut.
NOTE: Refer to Traction Unit Operator's Manual for
proper set–up procedure.
Rollers: Front roller is a 3" (76 mm) diameter cast
Wiehle roller. Rear roller is a 3" (76 mm) diameter steel
full roller. Both rollers use the same heavy duty ball bear-
ings with two conventional single lip seals and a Toro
labyrinth seal to provide four sealing surfaces to protect
the bearings.
Page 8.1 – 2 Rev. C Reelmaster 6500–D/6700–D