Front Panel; Rear Panel - Toshiba BDX2000KU Owner's Manual

Front Panel

1 2 3 4 5*
ON/STANDBY PAUSE STOP
(*) The unit can also be turned on by pressing these buttons.
ON/STANDBY Q button
1.
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
ON/STANDBY Q indicator
2.
PAUSE F button
3.
STOP C button
4.

Rear Panel

1 2
OPTICAL COAXIAL
HDMI
DIGITAL OUT
LAN
OUT
PCM/BITSTREAM
6
1. LAN terminal
• Use to connect a network equipment with LAN
cable.
2. HDMI OUT jack
• Use to connect a TV with an HDMI compatible port
using an HDMI cable.
3. AUDIO OUT jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with a composite audio cable.
4. COMPONENT VIDEO OUT jacks
• Use to connect a TV with component video inputs
with a component video cable.
5. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
8
INTRODUCTION
6* 7
PLAY OPEN/CLOSE
4
3
L Y
P /C
R R
P /C
R B B
AUDIO VIDEO
COMPONENT
OUT VIDEO OUT
7
8
PLAY B button*
5.
OPEN/CLOSE A button*
6.
7. Disc tray
8. Display
• Refer to "Front Panel Display" on page 11.
9. Infrared sensor window
10. SD card slot
6. DIGITAL OUT (OPTICAL / COAXIAL) jacks
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio optical / coaxial input jack with a digital audio
optical / coaxial cable.
7. VIDEO OUT jack
• Use to connect a TV, an AV receiver or other device
with a composite video cable.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
9
10
5
EN